News > Company News

How will you do when this problems arise after the Hifu treatment?

Add time:2017-06-30


Nowadays, people are more and more keep their attention on beauty, so after 30 years, there will be slackness in our face. Slackness is the source of the aging of the skin. No matter the overall looseness such as double chin and fuzziness of facial outline, or partial slack such as and nasolabial folds, they are all the signs of the incoming of slackness. High Intensity Focused Ultrasound was first applies to treat cancer and tumor, Later in the clinical experiments scientists found Transducer can focus the Ultrasound energy to reach the deep layer of the skin which laser can not, and make the target tissue in the focused area solidify. Then the surrounded tissue start to shrink, resulting in the up lifted skin. Because it leaves no trace on the epidermis, it became the new concept of non-invasive skin lifting, around the world.

图片1.png 

But Afer the Hifu treatment, how should we do if the patients face shows this problems?

 

1. Skin swelling

The reason:

(1) In the treatment you use a high energy

(2) customer skin foundation is not good

(3) Patients drinks a lot of water

(4) local moisture too heavy

The method:

Put the mask into the refrigerator, the patinets should take a mask on the face in the morning and evening, skin should make normal care, do not eat anti-inflammatory drugs, please avoid spicy food.

How to avoid this problem occour?

After the Hifu treatment the doctor should ice the skin, or make an ice mask on the face.

图片2.png 

 

2. skin rashes

The reason:

(1) Improper use of cosmetics

(2) Patient skin is too sensitive

The method:

Put the mask into the refrigerator, the patinets should take a mask on the face in the morning and evening, skin should make normal care, do not eat anti-inflammatory drugs, please avoid spicy food.

图片3.png 

 

 

3. Red spots appear on the skin(the focused spot)

The reason:

The cartridge did not touch the skin tightly

The method:

Apply the ice mask all over the face, apply aloe gel to the problem area, and then apply freeze-dried powder or repair fluid

How to avoid this problem occour?

Make the treatment cartridge touch the skin tightly

图片4.png 

 

4. The skin appears hard white spot

The reason:

Energy is too high

The method:

Apply the ice mask all over the face, apply aloe gel to the problem area, and then apply freeze-dried powder or repair fluid

How to avoid this problem occour?

Adjust the energy according to degree the patient can bare

图片5.png 

 

5. Skin epidermis raise

The reason:

Energy is too high and do not touch the skin tightly

The method:

Apply the ice mask all over the face, apply aloe gel to the problem area, and then apply freeze-dried powder

How to avoid this problem occour?

Adjust the energy according to degree the patient can bare, and touch the skin tightly

图片6.png 

 

6. The two side face is not balance

The reason:

The energy and the strength you use is not the same when make the treatment

The method:

Do the treatment again

How to avoid this problem occour?

Understand customer face size, make sure the strength and energy

图片7.png 

 

7. After the treatment the face wrinkle is deeper than before

The reason:

Operation is error

The method:

Do the treatment again

How to avoid this problem occour?

Strengthen the way to accurately understand the customer face problems

图片8.png 

 

 

 


Previous:How does Lipo Laser Slimming work?

Next:Doctor Answers tell you Is It Safe to Laser the Bikini Area?

<<  Back to list